|
Surfaces –
Miracle Shield can be used on the
following surfaces. NOTE: Outdoor
applications should be a minimum of two coats solution.
Finish –Miracle
Shield, will dry to a satin or low-luster semi-gloss finish. Which is
scratch resistant. There is no buffing required.
Application
- Miracle
Shield can be applied as follows: Miracle Shield hardens
best at a surface temperature of 55 degrees or higher on an average of 15 -
20 minutes.
Surface
Preparation - In order for Miracle Shield to work properly, the
surface must be free from any dust, dirt grease, grime or wax. You can
remove any oil, wax or grease with household rubbing alcohol.
Cleaning Properties –Miracle Shield
has no known cleaning properties such as some other multi-purpose sealants.
However, some applications have shown that mild mars, rust and stains have
been removed when applied.
Viscosity - The thickness of
Miracle Shield is determined by it’s application. The standard application
id either by brush, spraying or rolling. With standard applications, about 2
mil. of product is realized per coat.
Product Indications / Preparation
– Miracle Shield comes already mixed and ready for use right out of
the container. There is no mixing or dilution necessary.
Restrictions – Miracle Shield is
not to be used on glass, mirrors, chrome or brass.
Hazards – Miracle Shield is a
mixture of 55% water and 45% chemical solvent.
Product
Highlights
Protects Against
Guarantee – Miracle Shield is
guaranteed not to chip, crack, peel or yellow. Sold – Miracle Shield is available in 5 gal containers or 55 gal drums. |